Task 4, Final Motor Assembly
Press-fit the rotor body onto the motor shaft.
This is a friction fit. The motor shaft can be covered by a piece of heatshrink plastic to provide a firm fit to the hole in the center of the hardboard rotor body.
Solder the two motor wires to contacts on the printed circuit board (one to ground and one so that it can be electrically connected to the potentiometer).
Attach the motor mount sheet (with attached motor) to the printed circuit board with screws.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.